vacuum degasser is to remove air (oxygen) from the feed liquid, inhibit browning, oxidation of pigments, vitamins, aroma components and other substances, and prevent quality degradation; Remove the gas of suspended particles attached to the material liquid, inhibit the floating of particles and maintain a good appearance; Prevent foaming during canning and high temperature sterilization and affect sterilization; Reduce the corrosion on the inner wall of the container and play an anti-corrosion role.

Technical features:

1. It can greatly shorten the exhaust time after the initial water injection of the heating or cooling system, which is very conducive to the initial commissioning and operation of the system.

2. Remove the gas in the system, prevent gas resistance and ensure the stability and reliability of the system during normal operation.

3. Eliminate water pump cavitation and reduce system operation noise.

4. The removal of oxygen from water will reduce the aerobic corrosion of the system and prolong the service time of the equipment. 

5. Because the gas in the water is removed, there will be no gas bubbles on the surface of the heat exchanger, which improves the heating efficiency.

6. The working time and cycle of degasser can be adjusted as required.

7. The maximum capacity of a single applicable system can reach 150 m3; It can be used in parallel.

8. The equipment is easy to install, fully automatic, safe and reliable, and easy to maintain.

Use steps:

When in use, as long as the supporting vacuum pump is turned on (the pump is used according to the operation manual of the pump), the air in the device is pumped out, and the materials are sucked into the device from the feed port. When the materials rise to a certain position, the control valve automatically controls the materials. At this time, the feeding speed can be observed and controlled from the sight hole. When the vacuum in the device meets the process requirements, the materials can be extracted from the material outlet, As long as the vacuum degree and the balance of incoming and outgoing materials are maintained, the production can continue.